Hallo,

hab folgendes Problem:
über den ndiswrapper habe ich den Windowstreiber für die Broadcom 4306 eingebunden, und die Verbindung lahmt wie bei 56 K!

<u>Systemnachrichten:</u>

'cat /proc/net/ndiswrapper/wlan0/stats'

signal_level=-77 dBm
tx_frames=13056700580048
tx_multicast_frames=0
tx_failed=0
tx_retry=463856467968
tx_multi_rerty=180388626432
tx_rtss_success=0
tx_rtss_fail=0
ack_fail=820338753536
frame_duplicates=8589934592
rx_frames=0
rx_multicast_frames=37718402793472
fcs_errors=6283537154048

'lspci |grep Wireless'

02:03.0 Network controller: Broadcom Corporation BCM4306 802.11b/g Wireless LAN Controller (rev 03)

'dmesg | grep ndiswrapper'

ndiswrapper: module not supported by Novell, setting U taint flag.
ndiswrapper version 1.10 loaded (preempt=no,smp=no)
ndiswrapper: driver bcmwl5a (Broadcom,06/25/2004, 3.40.73.0) loaded
ndiswrapper: using irq 177
wlan0: ndiswrapper ethernet device 00:0b:7d:15:33:4b using driver bcmwl5a, 14E4:4320:1028:0003.5.conf

'iwconfig wlan0'

wlan0 IEEE 802.11g ESSID:"blabla" Nickname:"blabla"
Mode:Managed Frequency:2.457 GHz Access Point: 00:01:E3:05:ED:29
Bit Rate=11 Mb/s Tx-Power:25 dBm
RTS thr=2347 B Fragment thr=2346 B
Encryption keyff
Power Managementff
Link Quality:100/100 Signal level:-79 dBm Noise level:-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0


Ich hoffe mir kann jemand helfen!

Gruss Sven